Repair method when found wastewater membrane leakage Beijing integration equipment, the use of bubble observation locate leaks diaphragm, the diaphragm membrane removed from the shelves, clean sludge Beijing integration equipment, find broken membrane wire, in close the upper and lower portions of the left set of pipes 20 ~ 30cm, the remaining length of the truncated Beijing sewage integration equipment manufacturers, leaving a portion of each hit two membrane silk knot closure. If the film yarn cleavage site near the roots, not long enough to tie, then cut off with a razor blade at the base, into a stainless steel needle or special glue nail closure. If you are casting layer leaks, repair with special resin or glue, concrete can contact Jun Xin Environmental Technology Limited. Online chemical cleaning line chemical cleaning using an available chlorine concentration of about 1000mg / L (0.1%) of NaClO or ClO2 solution, the amount of liquid per m2 membrane area of ??1 ~ 2L plus the internal volume of the pipe. Cleaning steps are as follows: 1) prepare the necessary liquid; 2) stop production of integrated water pump equipment, pump inlet valve closed production; 3) about 2min, stop aeration; 4) turn dosing pump, about 90min the liquid slowly into the membrane; 5) closed dosing pumps, aeration valve opening; 6) backwash valve open, start backwash pumps, backwash system for about 2min; 7) Stop backwash pumps, backwash valve closed. 8) into the normal filtration system. Beijing integration equipment | integration equipment | Jun Xin environmental technology provided by the Environmental Protection Technology Co., Ltd. Nanjing Jun Xin. Nanjing Environmental Protection Technology Co., Ltd. Jun Xin (www.jxhb880.com) (www.jxhb880.com) strong, credible, in Nanjing sewage treatment equipment industry has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead Chun-hsin environmental technology and you hand into the brilliant, for a better future!